Services · Drywall installation
Commercial drywall installation
Gypsum board hung to the wall type on the drawings: 5/8" Type X as the commercial standard, moisture- and mold-resistant board in restrooms and wet areas, and fire-rated walls built the way the tested assembly says.
The right board in the right place
On commercial work, 5/8" Type X is the default for a reason: it is the board most fire-rated wall and ceiling assemblies are tested with, and it is stiffer and more forgiving than 1/2" board on steel studs. Where water is likely, in restrooms, janitor’s closets and around sinks, we hang moisture- and mold-resistant board instead. On the Richmond Ave job the whole building got 5/8" Type X, with purple moisture- and mold-resistant board in the bathrooms.
- Walls and ceilings in 5/8" Type X, and 1/2" board where the drawings allow it
- Moisture- and mold-resistant board in restrooms and wet areas
- Fire-rated walls hung to the listed assembly: layers, orientation and screw spacing
- Hard-lid ceilings, soffits and bulkheads
- Patch-backs after other trades, and openings closed after structural or MEP work
Hung with the finisher in mind
A good finish starts with good hanging. We use the longest practical sheets to cut down on butt joints, stagger joints from one side of the wall to the other, keep joints off the edges of door and window openings, and set screws just below the surface without breaking the paper. All of that means less mud, fewer ridges and fewer callbacks after paint.
Drywall installation
Common questions
Why 5/8-inch Type X instead of regular drywall?
Most fire-rated assemblies are tested with it, so it is often required, and many commercial specs use it everywhere for consistency. It is also stiffer on steel studs, which helps walls and ceilings stay flat.
Is moisture-resistant board the same as tile backer?
No. Moisture- and mold-resistant gypsum board is for areas that see humidity and splashes, like restrooms. Showers and other areas that get wet every day usually call for a cement or glass-mat tile backer instead; the drawings and the tile setter’s system decide.
Do you patch after the electrician and plumber?
Yes. Patch-backs and close-ups after other trades are a normal part of our work, priced on the estimate or as an add.
Have plans to price?
Send drawings or a scope sheet. We price framing, board, finish, grid, insulation and doors as one package, line by line.