Services · Tape, float & finish

Drywall taping and finishing

Tape, float, skim and sand to the level of finish the paint and the lighting call for, so the walls look right after paint, not just before it.

Tape, float, skim, sand

In Texas the coats of joint compound are called floating, and a good float is what separates a wall that disappears from one that shows every seam under a can light. Our standard sequence is tape, float, skim, sand and touch up, leaving the surface ready for the painter’s primer.

  • Taping flat joints and inside corners, and setting corner bead and trim
  • Floating joints, fasteners and beads in successive coats, each one wider and flatter
  • Skim coating where the finish level or the lighting calls for it
  • Sanding and touch-up after a light check, and again after the primer coat if the job needs it

Match the finish to the paint

The Gypsum Association’s finish levels, 0 through 5, are how specs say how much finishing a surface needs. Above the ceiling, Level 1 is usually enough. Most offices and clinics with flat or eggshell paint are fine at Level 4. Long corridors with light grazing the wall, gloss paint, or a lobby with big windows are where Level 5 earns its cost. We price the level the specs call for and flag the walls where it may not be enough.

Drywall finish levels 0 through 5 Six cross-sections of the joint between two sheets of drywall. Level 0 has no tape. Level 1 has tape set in joint compound. Level 2 adds a thin coat over the tape. Level 3 adds one more coat. Level 4 adds a second coat, feathered wider and sanded. Level 5 adds a thin skim coat over the entire surface. LEVEL 0LEVEL 1LEVEL 2LEVEL 3LEVEL 4LEVEL 5 NO TAPETAPE SET IN MUD+ THIN COAT+ ONE MORE COAT+ 2ND COAT, SANDED+ SKIM OVER ALL Temporary ornever seen Above ceilings,plenums, serviceareas Under tile,warehouses,garages Heavy texture orheavy wallcovering Flat paint, lighttexture, mostoffices and clinics Gloss or eggshellpaint, raking light,lobbies, corridors Levels as defined by the Gypsum Association (GA-214). The fastener heads get coats too: none at Level 1, one at Level 2, two at Level 3, three at Levels 4 and 5. Brown band = tape. White = joint compound, drawn far thicker than life.
Finish levels at a glance. More coats, wider feathering and finally a skim over the whole surface. Level 4 suits most offices and clinics; Level 5 is for gloss paint and harsh light.

Tape, float & finish

Common questions

What does ‘tape, float, skim’ mean?

Taping embeds paper or mesh tape in joint compound over every joint. Floating is the Texas term for the coats of compound that follow, each one wider and smoother. Skimming is a thin coat over a larger area, up to the entire surface for a Level 5 finish.

Which finish level do I need?

Look at the paint and the light. Flat or eggshell paint under ordinary office lighting is usually fine at Level 4. Gloss paint, dark colors, long corridors and walls next to big windows are candidates for Level 5. Our guide to finish levels explains each one.

Do you do texture?

We can, but most commercial interiors today are smooth. If the specs call for texture, the finish level underneath it can often be lower, which saves money.

Have plans to price?

Send drawings or a scope sheet. We price framing, board, finish, grid, insulation and doors as one package, line by line.

Request a bid